This is the configuration tab of the digital outputs in configuration tool.




The digital outputs are normally connected to the relay board and assigned a pin number which must be attached to the board.

Just like the digital inputs the pin and name can be modified by clicking on it, and we must choose the type Of output.

We can add new digital outputs by pressing the add button, located in the upper left of the tab ..

To edit click the “BLUE RELAY “ button to the left of the control.

In the outputs you can configure the logic activation value to relay as high level (HIGH pin to 5v.) Or as low level (LOW pin to 0v.), this configuration Is done in the general tab of the application.